Spring Testing Machine

HEICO manufactures Spring Testing machine in two models based on operation of the machine.
a.   Hand Operated Model
b.   Motorized Model

a. Spring Testing Machine (Hand operated)

The System has been designed to test springs of small range and medium range in Tension and compression.

The unit has a lever at front for loading and unloading of the specimen by controlling motion to the moving crosshead. A microprocessor based digital display unit which directly display the load in ‘N’ and displacement in mm. is also supplied. Load is being measured by the Load cell & is indicated in ‘N’ with a least count depending upon the capacity. The deformation is being measure by displacement sensor in ‘mm’ with a least count of 0.1mm. The system receives the output signal of the both the sensors as its input and amplify the same to be displayed on the LCD display at the front panel. 

A communication port (RS232) is also provided in the unit to transfer readings to the computer at an interval of 1 sec till specimen failure. 

Reset peak key is provided for resetting the peak value of Load achieved during the test.

b. Spring Testing Machine (Motorized)

This model is similar to hand operated one except that it has a motor which gives an accurate and controlled motion to the moving crosshead. It is suitable for operation on 220VAC supply. Selection can be made from various models based on capacities stipulated in the table.

Selection can be made from various models based on capacities stipulated in the table.