Deformeters

It is a sensitive instrument used to measure the change in distance between two gauge points on either side of the slot and consists of a frame with a handle on one end and a dial gauge of 0.002 mm x 10 mm travel fitted at the other end. The frame carries a fixed conical reference point on the handle side and a moving conical point on the dial gauge side. The plunger of the dial gauge rests against this movable point.

Deformeter, Gauge length 250 mm

HR 72.325

The equipment includes the following:-

  • Deformeter with a gauge length of 250 mm centre to centre of conical points and fitted with 0.002 mm x 10 mm dial gauge – 1 No.
  • Standardization Bar for 250 mm gauge length 1 No.
  • Spacer bars with threaded holes for gauge pins 250 mm centre to centre – 2 Nos.
  • Standard Gauge pins 12 mm square, with threads at one end having a conical seating for reference points. 4 Nos.
  • Necessary tools.

Complete as above in a polished wooden box.

Deformeter, Gauge Length 500 mm

HR 72.330

This is similar to HR72.325 except that it has a longer gauge length of 500 mm. The equipment comprises the following :-

  • Deformeter with a gauge length of 500 mm and fitted with a 0.002 mm x 10 mm dial gauge – 1 No.
  • Standardization Bar, gauge length 500 mm – 1 No.
  • Spacer bars with threaded holes for gauge pins. 500 mm centre to centre 2 Nos.
  • Standard Gauge pins, 12 mm square, with threads at one end having conical seatings for reference points – 4 Nos.
  • Necessary tools

Complete as above in a polished wooden box.

Standard Gauge Pin

HR 72.325.1

12 mm square cross-section, 100 mm long, threaded at one end and having a conical seating for reference point. Complete with a thread protection cap. Made of mild steel.Pack of 20